Reverse Crunch
- Primary muscleAbs
- EquipmentBodyweight
- DifficultyBeginner
- TypeCore · Core flexion
- Secondary muscles
- Hip Flexors
- Body part
- Core
- Position
- Lying
- Laterality
- Bilateral (both sides together)
- Category
- Strength
Track this exercise in SetGrip — no account needed
Curling the hips off the floor flips the crunch's usual direction - the pelvis moves toward the ribcage instead of the ribs toward the pelvis - which shifts emphasis toward the lower portion of the abs. The knees-to-chest motion is the easy part; the controlled lowering without the low back arching is where the exercise lives.
How to do the Reverse Crunch
- Lie flat on your back with your arms extended along your sides.
- Bend your knees and lift your feet off the ground, bringing your thighs perpendicular to the floor.
- Contract your abs and curl your hips off the floor, bringing your knees towards your chest.
- Pause for a moment at the top, then slowly lower your hips back down to the starting position.
- Repeat for the desired number of repetitions.
Tip: Breathe out as you crunch and let the last bit of air leave the lungs at the top of each rep.
Muscles worked
Primary
Abs · Core
The rectus abdominis shortens to bend the spine forward, and each rep should end with the upper abs fully contracted and the ribs pulled down.
Secondary
- Hip Flexors — The hip flexors take over if your feet are anchored and you come up too high; keep the range short to leave them out.
Common mistakes
- Pulling on the neck — hands behind the head should support, not yank; keep the elbows wide and the chin about a fist away from the chest.
- Sitting all the way up — a crunch is a curl of the ribs toward the pelvis, not a sit-up; the lower back should stay on the floor the whole time.
- Cranking out fast reps — momentum does the work if you bounce; lift to a squeeze, hold for a count and lower slowly.
- Never adding load — once bodyweight reps get easy, hold a plate on the chest or use a cable rather than doing sets of 50.
Sets, reps and where it fits
| Goal | Sets × reps | Rest |
|---|---|---|
| Strength | 3 × 8–12 | 60 s |
| Endurance | 2–3 × 15–25 | 45 s |
Crunches close out a session after the heavy work, or they can fill the rest periods between sets of a lift that does not need much bracing. Pair a cable crunch with a cable side bend on the same stack.
Variations and alternatives
Similar exercises
Frequently asked questions
What muscles does the Reverse Crunch work?
The Reverse Crunch primarily works the abs. It also involves the hip flexors, which assist the movement and stabilise the joints.
Is the Reverse Crunch good for beginners?
Yes. The Reverse Crunch is rated beginner: it uses no equipment beyond your bodyweight and the movement is simple to learn. Start light, focus on the full range of motion and add load once every rep looks the same.
What can I do instead of the Reverse Crunch?
If you cannot do the Reverse Crunch, try the Cable Reverse Crunch, the Cable Tuck Crunch or the Foam Roller Knee Tuck. Each of them trains the abs through a similar movement, so you can swap them in without changing the rest of the workout.
How many sets and reps should I do?
It depends on your goal. For the Reverse Crunch, a sensible starting point is strength: 3 × 8–12 with 60 s rest; endurance: 2–3 × 15–25 with 45 s rest. Train it at the end of a session or pair it with a lower-body lift as active rest.
Track the Reverse Crunch in SetGrip
All 1,100+ exercises with animations are in the app. No account, no sign-up — your data stays on your iPhone. Works with Apple Watch.
More exercises
Exercise data and animations are licensed ExerciseDB content used in SetGrip. This page is for general information and is not medical or coaching advice.