Incline Bench Barbell Reverse Wrist Curl
Also known as: chest supported barbell reverse wrist curl
In SetGrip: Barbell Reverse Wrist Curl (Incline Bench)
- Secondary muscles
- Biceps, Brachialis
- Body part
- Forearms
- Position
- Standing
- Laterality
- Bilateral (both sides together)
- Category
- Strength
Track this exercise in SetGrip — no account needed
Setting your forearms along an incline bench pad angles them downward, so the palms-down curl starts from a deeper extensor stretch than a flat bench or thigh setup allows. The chest-supported position also stops you from shrugging or leaning to help. It is a small tweak, but at these tiny loads the extra stretch is most of the stimulus.
How to do the Incline Bench Barbell Reverse Wrist Curl
- Sit on a bench with your feet flat on the ground and hold a barbell with an overhand grip, palms facing down.
- Rest your forearms on your thighs, allowing your wrists to hang off the edge.
- Slowly curl your wrists upward, bringing the barbell towards your body.
- Pause for a moment at the top, then slowly lower the barbell back down to the starting position.
- Repeat for the desired number of repetitions.
Tip: Use higher reps, 15 to 25, and lower the weight through a full three-second descent.
Muscles worked
Common mistakes
- Using the whole arm — the forearms should rest on a bench or your thighs with only the hands moving; if the elbows lift, you are cheating.
- Gripping hard on the descent — let the bar roll down to the fingertips at the bottom of a wrist curl for the full range before curling back up.
- Reverse curls too heavy — the wrist extensors are small, so use about half of what you use for regular wrist curls.
- Fast, short reps — go slowly through the full range and feel the stretch at the bottom, since jerky reps with a heavy weight are how wrists get irritated.
Sets, reps and where it fits
| Goal | Sets × reps | Rest |
|---|---|---|
| Muscle growth | 3–4 × 10–15 | 60–90 s |
| Endurance / finisher | 2–3 × 15–20 | 45 s |
| Strength | Not ideal — pick a compound lift for the same muscle | — |
Wrist curls go last in a session after all the pulling and gripping work is done. Superset regular and reverse wrist curls back to back with the same bar.
Variations and alternatives
Similar exercises
Without barbell
Easier and harder
Frequently asked questions
What muscles does the Incline Bench Barbell Reverse Wrist Curl work?
The Incline Bench Barbell Reverse Wrist Curl primarily works the forearms. It also involves the biceps and brachialis, which assist the movement and stabilise the joints.
Is the Incline Bench Barbell Reverse Wrist Curl good for beginners?
Yes. The Incline Bench Barbell Reverse Wrist Curl is rated beginner: it uses a barbell and the movement is simple to learn. Start light, focus on the full range of motion and add load once every rep looks the same.
What can I do instead of the Incline Bench Barbell Reverse Wrist Curl?
If you cannot do the Incline Bench Barbell Reverse Wrist Curl, try the Dumbbell Reverse Wrist Curl, the Bench Dumbbell Reverse Wrist Curl or the Single Arm Bench Dumbbell Reverse Wrist Curl. Each of them trains the forearms through a similar movement, so you can swap them in without changing the rest of the workout.
How many sets and reps should I do?
It depends on your goal. For the Incline Bench Barbell Reverse Wrist Curl, a sensible starting point is muscle growth: 3–4 × 10–15 with 60–90 s rest; endurance / finisher: 2–3 × 15–20 with 45 s rest. Do it after your compound lifts. It is a finishing movement, not the main event.
Track the Incline Bench Barbell Reverse Wrist Curl in SetGrip
All 1,100+ exercises with animations are in the app. No account, no sign-up — your data stays on your iPhone. Works with Apple Watch.
More exercises
Exercise data and animations are licensed ExerciseDB content used in SetGrip. This page is for general information and is not medical or coaching advice.