Low Glute Bridge

Secondary muscles
Hamstrings, Abs
Body part
Upper Legs
Position
Lying
Laterality
Bilateral (both sides together)
Category
Strength

Track this exercise in SetGrip — no account needed

Stopping short of full extension keeps the hips low and the range small, which is exactly the purpose: constant glute tension without the rest a full bridge allows at lockout. Treat it as a regression when full bridging is too demanding, or as a burnout of slow pulses at the end of glute work.

How to do the Low Glute Bridge

  1. Lie flat on your back with your knees bent and feet flat on the ground.
  2. Place your arms by your sides, palms facing down.
  3. Engage your glutes and core, then lift your hips off the ground until your body forms a straight line from your knees to your shoulders.
  4. Pause for a moment at the top, squeezing your glutes.
  5. Slowly lower your hips back down to the starting position.
  6. Repeat for the desired number of repetitions.

Tip: Push through the heels, drive the knees out slightly and exhale as you squeeze to the top.

Muscles worked

Primary

Glutes · Legs

The glutes extend the hips against the bar and should be squeezed hard at the top of every rep, where the tension is highest.

Secondary

  • Hamstrings — The hamstrings assist the glutes and will take over if the feet are too far forward or the knees are too straight.
  • Abs — The abs keep the ribs down and the pelvis tucked so the movement comes from the hips rather than the lower back.

Common mistakes

  • Overarching at the top — the finish is a flat line from shoulders to knees with the pelvis tucked; if the lower back arches, you have gone too far.
  • Feet placed too far out — shins should be vertical at the top of the rep; if the heels are too far forward the hamstrings take over.
  • Chin pointing at the ceiling — keep the chin tucked and the eyes forward so the ribs stay down and the glutes get the squeeze.
  • Not pausing at the top — hold the lockout for a full count and squeeze the glutes hard on every rep, since that is the whole point.

Sets, reps and where it fits

GoalSets × repsRest
Strength4–5 × 3–62–3 min
Muscle growth3–4 × 6–1290–120 s
Endurance2–3 × 12–2060 s

Hip thrusts can be a main lift early in a glute day or an accessory after squats and deadlifts. Superset them with a band abduction or a leg curl using the same bench setup.

Variations and alternatives

Similar exercises

Without bodyweight

Easier and harder

Frequently asked questions

What muscles does the Low Glute Bridge work?

The Low Glute Bridge primarily works the glutes. It also involves the hamstrings and abs, which assist the movement and stabilise the joints.

Is the Low Glute Bridge good for beginners?

Yes. The Low Glute Bridge is rated beginner: it uses no equipment beyond your bodyweight and the movement is simple to learn. Start light, focus on the full range of motion and add load once every rep looks the same.

What can I do instead of the Low Glute Bridge?

If you cannot do the Low Glute Bridge, try the Feet Elevated Glute Bridge, the Pelvic Tilt to Glute Bridge or the Feet Elevated Barbell Glute Bridge. Each of them trains the glutes through a similar movement, so you can swap them in without changing the rest of the workout.

How many sets and reps should I do?

It depends on your goal. For the Low Glute Bridge, a sensible starting point is strength: 4–5 × 3–6 with 2–3 min rest; muscle growth: 3–4 × 6–12 with 90–120 s rest; endurance: 2–3 × 12–20 with 60 s rest. Put it early in the session while you are fresh, before isolation work for the same muscles.

Track the Low Glute Bridge in SetGrip

All 1,100+ exercises with animations are in the app. No account, no sign-up — your data stays on your iPhone. Works with Apple Watch.

More exercises

Exercise data and animations are licensed ExerciseDB content used in SetGrip. This page is for general information and is not medical or coaching advice.